Flatbed Vehicle charging for Winch
This flatbed needs vehicle charging trailer batteries for a winch. Crazy how some trailer manufactures cheap out on proper gauge for 12+ and electric brake. Upgraded wires for 12V supply and ground.
This flatbed needs vehicle charging trailer batteries for a winch. Crazy how some trailer manufactures cheap out on proper gauge for 12+ and electric brake. Upgraded wires for 12V supply and ground.
7 Pin with auxiliary wire. 30 amp fuse. Battery isolator. Notes: Aux hot will drain trailer battery. Vehicles max draw 5-15a (not the 30a fuse that is recommended). Must isolate trailer from vehicle when not connected. Trailer: isolate aux power…
Customer wanted two more batteries for their dump trailer. Dump all day without running low on battery.
Well, it fried. 33 mins. Was hoping it was 30mins. Moan flows way much better. 10 yr warranty. Can’t beat that. The InSinkerator brand was slow to drain (even new).
Dana 80 350k mi service. Didn’t even have half a quart oil. I think what happen was the rtv wasn’t allowed to set before cranking down. 4qt 12oz is what it takes.
These welds look terrible. Came straight from the factory.
Rental says they were charged $200 for this repair and it took less than 10mins 🙁 This isn’t going anywhere. If this is to break off, it is going to take the rails with it.
25ft of 2ga wire is needed to run from battery to back bumper. 25ft gives about 3ft of wiggle room. I’m done using quick connects. Since I do a lot of welding and I use welding leads. I use dinse…
Store battery for winch and other goodies
Welded to the side for easy serviceability